Sportbike Racing Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
1,396 Posts
Discussion Starter · #1 ·
Here's a pic that explains the whole rear turn signal
thing Josh. (And anyone else that needs it.)

I did have to trim my spacers 1/8" to make it fit right.
Most say you shouldn't have to though.





 

·
Registered
Joined
·
5,417 Posts
Sabre, got done a little while ago, they look great! Thanks again for the pic and instructions. Now if I only had a digi camera like I said I was going to buy!

 

·
Registered
Joined
·
1,396 Posts
Discussion Starter · #5 ·
No problem Josh, told ya it was not hard.

Like the addition to the sig pic, but I think the
beer guzzler suits you better./images/icons/wink.gif




 

·
Registered
Joined
·
1,396 Posts
Discussion Starter · #6 ·
Anyone else have to trim the spacer a bit?
I had to cut 1/8" off the tube the wires run through
to make everything fit.

 

·
Registered
Joined
·
26 Posts
No, mine worked perfectly. It only took about 20 mins and I didn't have to cut anything. I did notice that they are not as solid as they were, they sort of float arround on that soft rubber bushing. But I don't think they will move.
 

·
Registered
Joined
·
5,417 Posts
Kawi12R, I had the same results. Didn't have to trim anything but the signals are just a bit looser than they were before, but nothing to complain about. Like you said, I don't think they are going to be moving around when going over bumps or anything. I love the way it looks.

 

·
Registered
Joined
·
1,396 Posts
Discussion Starter · #9 ·
Ok, mine were a bit loose, and I trimmed to tighten
them up.
Guess I was just paranoid with them moving around.
They are pretty solid now.

 
1 - 9 of 9 Posts
Top