Sportbike Racing Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
74 Posts
Discussion Starter · #1 ·
I am going to be making a 2 into 1 system for my Superhawk and have some dimensional questions on the current aftermarket systems out there.

1. Inside diameter measurment of the canisters/silencers? This can be the outlet tube ID or preferably the ID of the perforated tube inside.

2. Outside diameter and over-all length of the canister?

Reason for my making this system is simply it will be different. I will eventually have some pix and dyno comparison numbers and will let everyone know how this ends up.

Thanks much in advance:)

IcerDave
 

·
Registered
Joined
·
74 Posts
Discussion Starter · #5 ·
Edwards in Spain was also runnig same set-up as US bikes.

I am not looking for all out power, their's enough there already. I little more punch in the midrange is ok tho. But a little work may yeild some interesting results.

the outlet size will be vary close to the tube size entering the silencer.

tia
 

·
Registered
Joined
·
74 Posts
Discussion Starter · #6 ·
any one?

just take a ruler or dial calipers and measure where the exhaust comes out of your pipe. Also look inside to see if the perforated baffling is smaller. I need the smallest dimension.

Thanks again
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top