Sportbike Racing Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
71 Posts
Discussion Starter · #1 ·
As I said in my other post, I ordered a full race Akro system, and I am going to try to install it myself, and then have a dealer do the jetting. (By the way, I ordered an Ivan's kit for that.) I was looking at the EXUP last night on my bike and I noticed a mess of wires running up into the engine area. Is this something I can remove myself or should I just have the dealer do it? Any instructions or advice would be a great help!

Thanks,
Chris

Say hello to my little friend...
 

·
Registered
Joined
·
3,700 Posts
Just drop the headers and collect/EXUP... You'll notice 2 cables running up to the left side of the engine, just slide the cables of the pulley's on the servo motor and you are done. Or you can take the servo out completely but make sure you do the resistor mod or get Sam's Servo replacement.

I personally left my servo in, I didn't want to deal with the potential problems of saving a pound or two.
 
1 - 3 of 3 Posts
Top