Sportbike Racing Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
27 Posts
Discussion Starter · #1 ·
I need help.........!!!!!!

I have a new red aluminum micron s-bend high mount slip-on and there is a drip coming from the end can near the rubber between the end can & connector.

When riding it spits driplets on swingarm, while stopped it creates a small puddle beneath.

Also is it normal that the end can and connector pipe when attached & tightened still be a little loose. If I grab the can it moves a little up/down @ the connecting point???

Please give me feedback......its driving me crazy!!
 

·
Registered
Joined
·
5,356 Posts
is it water ? from condensation when heating up? never had that prob. what color is it
 

·
Registered
Joined
·
5,356 Posts
on my r6 it would drip a little where the pipe met the header cause the seal was not 100%. next time you start your bike after about 10-15 sec. put your hand over the exhaust hole. rev it. i bet your hand has water spots on it. its just the moisture from inside the can seeping out most likely. tighten the connections and wipe off. shouldn't be a prob
 
1 - 6 of 6 Posts
Top